Electronics & Wiring¶

Info

This section of the assembly manual is split across multiple sections. Take note that some of the parts listed below will be used at different points in the build.

Tools

M3 Driver
Flush Cutters

Difficulty

Easy

Page: /

Archim2 Mainboard¶

Warning

To connect all of the sensors, cables, and ports in your printer, it's important you try to mirror the diagrams and notes below. Failure to do so can result in safety issues.

Info

All of the following direction information assumes that your Archim2 is oriented such that the Atmel logo isn't upside-down.

Extruder¶

Your extruder stepper motor connects to the second port from the left.

The thermistor wires for your heater are in ports 1 and 2, closest to the center of the board.

Your heater cables for the extruder connect to the rightmost ports on the bottom for heaters, labeled on the Archim2 as Heat 0 / Heat 1.